Kason 8600EZ, Руководство по установке

Страница: 15 / 17

INSTALLATION INSTRUCTIONS
© 2019 Kason Industries, Inc. IS-8600EZ-200 Rev 6 03/19
kasonind.com | 1.800.935.2766 | PAGE 15
8600EZ Power Drive
Single Doors and Bi-Parting Doors
Part Number: 8600*
The Controller Navigation Buttons are: Escape, Enter, Up, Down
Step 9. Turn on the AC Power
If upon power up, the display reads: 1
st
Line Company Name
2
nd
Line Cycle Count
Step 10. Door Size Calibration
A. Press the “
Up
” or “
Down
” button until the display reads “
AutoCal Now
”
i. Press the “ Enter ” button.
ii. Display should read “ ENTER to Calibr ”
NOTE
: To exit “
AutoCal
Now” mode, press the “
Down
” button once for the display to show “
Return to Main
”
then press “
Enter
” to return to the main menu.
B. Press the “
Enter
” button. (The door will cycle to open, then close.)
i. The door should move toward the open position at a slow speed.
NOTE
: If the door moves toward the close position, jump to
Step 11
.
• During opening, the display will show “
Status, Calibrate Open
”.
• At the open position, the door will press against the open stop retainer.
ii. Upon completing B(i) , the door will auto-reverse direction
• During closing, the display will show “ Status, Calibrate Close ”.
• At the close position, the door will press against the close stop retainer (or the two leaves press together with a
bi-parting door) and stop.
• The display should read “
Door Size Stored
”, “
Cycle to complt
”.
C. Cycle the door as follows to complete calibration
• Open the door using the “Open” button switch connected to Input 1.
(See Step 8 , Connector D, pins 1 and 2). The door should open faster than during calibration.
• Close the door using the “Close” button switch connected to Input 1.
(See
Step 8
, Connector D, pins 3 and 4). The door should close faster than during calibration.
SYSTEM IS NOW READY TO USE
Step 11. Direction Reverse
A. Power down the system until the screen goes blank, then power back on.
B. Press the “
Up
” or “
Down
” button until screen displays “
Ent Pswd
”.
C. Press the “Enter” button, then the following sequence of buttons to change direction: ENTER , DOWN , DOWN ,
ENTER , ESC , ESC , ESC , ESC .
D. Press the “ Up ” or “ Down ” button until display reads “ Dir Flip ”.
E. Press the “
Enter
” button.
F. Press the “
Up
” button to change value from 0 to 1 or the “
Down
” button to change value from 1 to 0.
G. Press the “ Enter ” button to save this value.
i. Power down the system and repeat Step 10 .