RGBC5 WATERGLOW LIGHTING MANUAL
7
CONTROL PANEL INSTALLATION & OPERATION
1.
Open the control box and remove the operating instruction sheet, remote control, and battery. Insert
the battery into the remote control. If the battery is already inserted, remove the plastic battery guard
from the remote to active the battery connection.
2.
The RGB control box is ready to mount next to your Kasco fountain control box (mount a minimum of
5ft from water) using two exterior-grade wood screws; one for the top and one for the bottom hanger.
Tighten the top screw to prevent the box from lifting off the screws. Mount close enough for the power
cord to reach the receptacle or terminals labeled “Lights” in the fountain control box.
3. Once mounted, connect the RGB light kit power cord to the field terminal connections in the RGB control
box. Connect: White to White, Green to Green, Red to Red, and Black to Black.
4.
For 120V fountain control box:
Plug the RGB control box into the “Lights” receptacle in the fountain
control box. This will allow the C-25 control panel to control the lights and the fountain through the tim
-
er. To energize the C-25 light receptacle, the photo-eye of the C-25 will need to be covered (to simulate
nighttime conditions). Refer to your C-25 instructions.
For 240V or 3phase fountain control box:
If you have a Kasco C-85, C-95 or 3phase control panel, you
will need to hardwire the RGB controller power cord to the light terminals in your fountain control panel.
Refer to your fountain owner’s manual for connection information. The Kasco C-85, C-95, and 3phase
control panels use a timer for controlling the light output. Ensure the light timer is set as required. Refer
to your fountain owner’s manual for timer setting instructions.
5.
With the RGB controller door open, a red LED “Power” indicator on the RGB control module will be seen.
If this indicator is not on, then power is not being sent to the RGB control box.
6. The RGB controller is operated with the included remote control. The controller will operate in the last
mode set until it is changed with the remote. Before use, remove the clear plastic tab at the base of the
remote. The figure on the next page details the remote control’s functions. The green signal indicator
(on the RGB controller) will flash while the remote is communicating to the controller.
3.5mm Audio Jack
Mic input level adjustment
Connect light kit power cord
wires to this terminal block.
Signal indicator
Do NOT power on RGB control box at this time.
Back to Contents
