LED4S19 UNIVERSAL STAINLESS STEEL LIGHTING
MANUAL
884055 / 2021.1.2
5
Fig. 6
Fig. 7
Fig. 8
4�
Use a 1/4”-20 x 3/4” screw (J), flat washer (H),
lock washer (E), and hex nut (G) to secure a
Universal mounting bracket (I) to each S19
bracket (F), as shown in Figure 7.
5�
Use either a 2-1/2” (L) or 1-3/8” hex screw (M,
not pictured), fender washer (K), lock washer
(E), and hex nut (G) to secure the bracket to
the float.
Hardware is provided for basic installation. Check your installation to ensure you have the correct hardware. Additional hardware may
be included, or you may need to purchase it if your installation varies from the diagrams below�
For vertical bracket mounting, use the hardware
shown in Figure 7 above to fasten the two brack
-
ets together. Then use your existing float screws
through the slot in the Universal bracket to secure
it. For additional vertical options, flip the LED light
bracket (F) upside down.
Fig. 9-10
6. Repeat for remaining fixtures, spacing evenly around the float. Cable ties can be used to attach the fixture cords to float, decrease
play, and ensure protection. Cable-tie the light kit power cord to the float opposite the fountain power cord for balance and to
prevent damage from the fountain. Remember: LEDS19 fixtures MUST be properly submerged (to mark on housing) to avoid
overheating�
Back to Contents
