ROBUST-AIRE MANUAL
4
LARGE CABINET INSTALLATION
Choose a location far enough from shore to avoid potential flooding. If you use plantings to help hide the
cabinet, be sure that both the inlet and the outlet vents are clear, as the compressor requires airflow to
prevent overheating. The best foundation options include pea gravel, rubber mulch, and cement.
Place the assembly directly on the ground or attach it to a concrete pad. Use the holes on the bottom
flanges to anchor the cabinet.
Place the cabinet adjacent to the electrical service which will power the system. The cabinet has 6-foot
power cords with plugs.
DO NOT USE EXTENSION CORDS.
For remote manifold installation information, see supplementary instruction sheet.
Use the clamps
included with the
SureSink Tubing
kit to complete
connections to the
compressor.
3/8" mounting holes (x4)
37"
17 1/16"
42 1/8"
20 11/16"
19 5/8"
REV.
ECO#
DESCRIPTION
DR'N BY
DATE
DES ENG CH'K BY
1
INITIAL RELEASE
774085
DO NOT SCALE DRAWING
C.A.D. GENERATED DRAWING
800 DEERE ROAD
PRESCOTT, WI 54021-1241
MANIFOLD, COMPLETE ASSEMBLY
RA, 4 COMPRESOR, CABINET
5052 Aluminum
THIS DRAWING CONTAINS PROPRIETARY
INFORMATION AND SHALL NOT BE USED,
REPRODUCED OR DISTRIBUTED WITHOUT
THE PRIOR WRITTEN CONSENT OF
KASCO MARINE, INCORPORATED
.X .02 [.508] .XX .010 [.254]
.XXX .005 [.127] ANGULAR 0.5
UNLESS OTHERWISE SPECIFIED
DIMENSIONS ARE IN INCHES.
DIMENSIONS IN [ ] ARE MILLIMETERS.
TOLERANCES ON:
THIS DOCUMENT HAS BEEN ISSUED
FOR ENGINEERING INFORMATIONAL
PURPOSES ONLY. ANY REVISIONS
TO THE CONTENT OF THIS DOCUMENT
MUST BE INCORPORATED INTO THE
ORIGINAL CAD FILE.
THIRD ANGLE PROJECTION
TITLE:
774085
SHEET 1 OF 1
FINISH:
MATERIAL:
SCALE: 1:5
DWG. NO.
774085
DO NOT SCALE DRAWING
C.A.D. GENERATED DRAWING
800 DEERE ROAD
PRESCOTT, WI 54021-1241
MANIFOLD, COMPLETE ASSEMBLY
RA, 4 COMPRESOR, CABINET
5052 Aluminum
THIS DRAWING CONTAINS PROPRIETARY
INFORMATION AND SHALL NOT BE USED,
REPRODUCED OR DISTRIBUTED WITHOUT
THE PRIOR WRITTEN CONSENT OF
KASCO MARINE, INCORPORATED
.X .02 [.508] .XX .010 [.254]
.XXX .005 [.127] ANGULAR 0.5
UNLESS OTHERWISE SPECIFIED
DIMENSIONS ARE IN INCHES.
DIMENSIONS IN [ ] ARE MILLIMETERS.
TOLERANCES ON:
THIS DOCUMENT HAS BEEN ISSUED
FOR ENGINEERING INFORMATIONAL
PURPOSES ONLY. ANY REVISIONS
TO THE CONTENT OF THIS DOCUMENT
MUST BE INCORPORATED INTO THE
ORIGINAL CAD FILE.
THIRD ANGLE PROJECTION
TITLE:
774085
SHEET 1 OF 1
FINISH:
MATERIAL:
SCALE: 1:5
DWG. NO.
Back to Contents
