Kasco LED6S19-150, Руководство пользователя

Страница: 3 / 12

3
provide at least the same submersion to properly cool
the ixture. Operating the ixtures out of water will
damage the LED and void warranty.
2. Insert the ¼” x 1-3/8” bolt into the light mounting
bracket. Align the bracket to the loat tab by placing
the bolt through the light mounting hole (mounting
bracket is on top of the loat tab) as shown in Fig. 2
Fig 2:
3. Install the ¼” Flat Washer, ¼” Lock Washer and
¼” Nut against the underside of the loat tab as shown
in Fig. 3. Tighten the nut until snug using the 7/16”
wrench.
Fig 3
lat washer
lock washer
1/4” nut
4. Adjust the angle of the light as desired and tighten
the ¼” x ½” bolts on the sides of the mounting bracket
until snug. For more uniform illumination, it is best to
have all three ixtures at the same angle.
5. Repeat steps 1 through 4 for the remaining ixtures.
Assembled light ixtures are pictured in Fig. 4. Note
the orientation of the lights and mounting brackets.
Fig 4
• ¼” Stainless Steel Flat Washer (6)
• ¼” Stainless Steel Nut (6)
• ¼” x ½” Stainless Steel Bolt (12)
• ¼” x 1” Stainless Steel Bolt (6)
• Nylon Cable Ties (12)
• Lower Float Brackets (6)
• 3/8” Stainless Steel Flat Washers (3)
TOOLS & SUPPLIES NEEDED
• Two 7/16” wrenches (or one wrench & a 7/16”
socket with driver)
• Two 9/16” wrenches (or one wrench & a 9/16”
socket with driver)
• Wire Cutter (for trimming cable ties)
LED3S19 Assembly Instructions
For ease of assembly, make sure the Aerating Fountain
is completely assembled. Place the assembly upright.
Instructions for mounting LED3S19 on models:
2400VFX, 3400VFX, 3400HVFX, 3400JF, 3400HJF,
4400VFX, 4400HVFX, 4400JF, 4400HJF
1. Install the mounting brackets to the light ixtures
as shown using ¼” lock washers and ¼” x ½” bolts.
Hand tighten only at this time.
Fig 1
Important Note: Installation of the LED light ix
-
tures on the above listed aerating fountain units with
the mounting brackets oriented as shown will ensure
proper submersion of the light ixtures. Each ixture
must be partially submerged in order for lights to oper-
ate properly. Other applications for these ixtures must