2HP-5HP AERATOR MANUAL
7
ASSEMBLY INSTRUCTIONS (2HP)
1.
Arrange the three float sections (A) upright
(plug on bottom) so the overlap of one sec-
tion aligns with the next section and loosely
push the three sections together to form a
continuous ring.
2.
Position one top float bracket (D) so that the
bolt holes in the bracket align with the bolt
holes in the two adjoined float sections.
3. Insert two 9.5” hex head screws (B) through the
assembly. This may require some minor repo-
sitioning of the float sections as you push the
bolt all the way through. Do not force the bolt
through. Repeat for the remaining two joints.
4.
Turn the assembly upside down and place the bottom float brackets (G) over the bolts, the ends of
which should now be extending through the assembly.
5. Loosely install the six 3/8” lock nuts (C) on the ends of the bolts (do not tighten yet).
6.
Connect the top and bottom float brackets using three 3/8" x 1" bolts (E) with three 3/8" lock washers (F)
and 3/8" nuts (C). Tighten using the 9/16” wrench.
Float up
Float down
Plug
B
D
2
3
4
G
C
E
C
5
6
I
J
Top hole
7.
Loosely attach the unit mounting brackets (H) to the float
brackets with three 1/4”-20 x 3/4” screws (I) and 1/4” lock
washers (J) in the top mounting hole as shown. Do not
tighten, since you will need to pull the unit mounting bracket
away from the top float bracket to accommodate the cage
ring once the float and unit are in place.
H
7
A
F
Back to Contents