3
3. Place rubber caps over the light ixtures as shown.
Ensure the rubber cap is seated all the way down onto
the ixture housing. If this is not on a new light kit,
make sure the ixture and lens are clean before install
-
ing the rubber cap.
Fig 3
Instructions for mounting lights on model:
2400VFX, 3400VFX, 3400HVFX, 3400J, 3400HJ,
4400VFX, 4400HVFX, 4400J, 4400HJ
4. Insert the 1/4” x 1-3/8” bolt into the light ixture
bracket. Align the light ixture bracket to the loat
tab by placing the bolt through the light mounting
hole (light ixture bracket is on top of the loat tab) as
shown in Figure 4.
Fig 4
5. Install the 1/4” Flat Washer, 1/4” Lock Washer
and 1/4” Nut against the underside of the loat tab as
shown in Figure 5. Tighten the nut until snug using
the 7/16” Wrench.
Fig 5
lat washer
lock washer
1/4” nut
LED6125 / LED6C11
• A. Includes two (2) sets of LED3125 or LED3C11
(see parts included in LED3125 / LED3C11
•
B. Lower loat brackets (6)
• C. 3/8” washers (3)
TOOLS & SUPPLIES NEEDED
• A. Two 7/16” Wrenches (or one wrench & a 7/16
socket with driver)
• B. Diagonal Pliers or Cutter for Nylon Zip Ties
Assembly Instructions
For ease of assembly, make sure the Aerating Fountain
is completely assembled. Place the assembly upright.
1. Install the mounting brackets to the light ixtures by
itting the head of the #10 screw into the tabs on each
side of the ixture. Tighten the thumb screws on each
side hand tight only.
Fig 1
Installing Color Lenses:
If you desire to change to one of the color choices
instead of the standard white light, follow these steps.
2. Unpeel the protective backing from both sides of
the colored lens on the color of your choice. Place the
lens inside the rubber cap making sure the 3 laps are
holding the lens in place. Do this for all 3 lenses.
Fig 2
