3
Halyard connection.
Splice your halyard and fit it into the male part (G). The splice should feature a max diameter of 10.5mm.
Insert the 10mm pin into the splice and secure it with the Two M5 screws with Loctite.
3 OPERATING THE SYSTEM
The systems is activated and deactivated with the same halyard.
To facilitate the engagement and disengagement of the locking mechanism, the male part needs a 2-3cm slack to go
up and down the female part.
Please note that if the luff of the sail is tensioned when the locking mechanism is being engaged, the locking
mechanism could be partially activated only and result to damage or failure of the internal halyard lock.
To lock:
Pull the halyard to the max hoist limit (until the male part reaches the first end stop) to activate the locking
mechanism. The system is locked.
We recommend to make a mark on the halyard at full hoist which will act as point of reference.
