31
Adjusting the Seat Height
Figure 7.5
Note:
You will need two 17mm wrenches to adjust the seat height. Your Karma service
provider would be happy to assist you in adjusting the seat height.
◎
The frame post is comprised of the upper and lower frame posts. The upper frame
post adjusts the height by sliding inside of the lower frame post and the two are
secured through the connection of two hearty bolts. The top bolt is threaded and is
designed for added stability. It only goes through the front side of both frame posts.
The lower bolt goes all the way through both frame posts and sets the seat height. It is
not threaded as it passes through the seat posts, but has a hex nut on the backside.
The seat post rests in the frame post. There are four holes in the frame post to allow
you to adjust the seat height to 18.5" (47cm), 19.4" (49.5cm) or 20.4" (52cm).
◎
To adjust the seat height, remove the seat by following the previous instructions. Next,
remove both bolts from the two frame posts. (You might want to disconnect the
batteries to allow more room to work).
Slide the upper frame post up or down to the desired position. Place the seat height
adjustment bolt in the lowest hole (of the upper frame post) and tighten its hex nut using
two 17mm wrenches. Use one 17mm wrench to insert the threaded stability bolt in the
second lowest hole (of the upper frame post which is also threaded).
Now you can replace the rear casing and install the seat using the previous instructions.
Wasn't that a hoot? Let's do it again.
