Silence Alarm and Reset system
Silencing an Alarm
If an alarm occurs whilst you are in or near to the premises the alarm can always be silenced by entering
your code. If the system was set it will be unset at the same time. If the alarm occurs while you are away
from the premises the outside and inside sounders will automatically stop after the bell time programmed by
the engineer, see your SIS for the bell time.
When you enter your code after an alarm, the keypad will display the cause of the alarm on the top line.
INTRUDER
BACK DOOR
The second line shows additional information, such as the point which caused the alarm. The system will
now need to be reset as described in the next section.
Resetting after an Alarm
After an alarm the system will need to be reset by entering a suitable reset code. The display will alternate
between the alarm cause and a prompt to enter a reset code.
Enter Your
Code
If the this prompt is displayed you can reset the system using your own code. Key in your code and press
the ENTER key.
After the system has been reset it may enter a fault lockout described in the next section.
Engineer Reset
Required
If this prompt is displayed you may need to call out the engineer to reset the system.
