Karibu 47370, Инструкция по сборке

Страница: 106 / 212

WORLD OF WELLNESS
EN
Instructions for installation and use p. 9/22
4. Installation and connection
ATTENTION!
Damage to the unit
The sauna control unit is protected against water splashes, however direct contact
with water could still damage the unit.
● Install the sauna control unit in a dry place at which a maximum humidity of
95% is not exceeded.
Observe the following points when installing and connecting the sauna control unit:
● The sauna control unit must be installed outside the sauna cabin at a height
of approx. 1.70 m, or in accordance with the recommendation given by the
sauna manufacturer. The ambient temperature should not exceed 40°C.
● The heater sensor wires must be laid separately from the other mains wires
and control wires. Wires with only one layer of insulation must be protected
by using a pipe (double insulation).
● The heater sensor must be installed in the sauna cabin above the sauna
heater. A distance of approx. 15 cm to the roof of the sauna cabin must be
maintained.
● The heater sensor must be attached in a way that ensures it is not affected
by inflow of air.
● The bench sensor must be installed opposite the heating system. A distance
of approx. 15 cm to the sauna cabin ceiling must be maintained.
ATTENTION!
Damage to the unit
● The sauna control unit may only be used for operating and regulating one
heating circuit with a maximum heating capacity of 3.6 kW and a maximum
evaporator capacity of 1.2 kW.
WARNING!
Risk of electric shock
● Installation and connection of the sauna control unit may only be
performed when the power supply is disconnected.
● NEVER remove the housing of the sauna control unit.