Kärcher WPC 100 RO, Руководство пользователя

Страница: 12 / 180

-
4
몇 WARNING
Health hazards on account of improperly repaired appli-
ance. The appliance may only be repaired by trained
and skilled personnel.
Use only original parts of the manufacturer or part sug-
gested by him, such as
–
parts and wearing parts,
– accessories parts,
– operating materials,
– cleaning agents.
Before doing any work on the machine:
 Shut off water supply.
 Turn on the filtered water tap to depressurise the
unit.
 Pull out the mains plug.
In order to ensure a reliable operation of the device, we
recommend that you conclude a maintenance contract.
Please contact your competent KÄRCHER service.
The filters installed in the unit must be replaced at reg-
ular intervals. This interval depends on use. An over-
view of the recommended filter replacement intervals
can be found at the end of these instructions.
몇
WARNING
Health risk due to the contamination with germs.
When replacing the filter cartridges, ensure hygiene and
cleanliness.
Do not touch the connections of the socket and filters.
Wear disposable gloves when replacing a filter.
Do not damage the seals during installation and remov-
al.
Note
Used filters can be thrown away with household rub-
bish.
1 Fine filter
2 Activated carbon filter (granulate)
3 Activated carbon filter (block)
4 Membrane filter 1 (reverse osmosis)
5 Membrane filter 2 (reverse osmosis)
6 Active carbon filter
ATTENTION
Risk of water damage. The filter chambers are full of
water. Place a suitable container or dish underneath be-
fore removal.
 Unscrew the filter chambers using the included
black spanner.
 Replace the filter.
Note
Filters must be installed in the same position and must
not be interchanged! Observe the illustration.
Make sure the seals are seated properly during installa-
tion.
Only hand-tighten filter chambers using the included
black spanner.
ATTENTION
Risk of water damage. The membrane filter chambers
are full of water. Place a suitable container or dish un-
derneath before removal.
 Disconnect the hose connections and remove the
hoses.
 Remove the upper activated carbon filter.
 Remove the membrane filters from the brackets.
 Unscrew cap using the included white spanner.
 Use a tool to carefully loosen membrane insert.
 Carefully pull membrane insert out of casing by
hand.
 Insert new membrane insert.
 Screw cap back on.
 Insert membrane filter into the bracket.
 Reconnect hoses.
Note
The upper activated carbon filter at the end of the filtra-
tion system does not have a filter insert and must be re-
placed in its entirety.
 Disconnect the hose connections and remove the
hoses.
 Remove the upper activated carbon filter.
 Install new activated carbon filter.
 Reconnect hoses.
We hereby declare that the machine described below
complies with the relevant basic safety and health re-
quirements of the EU Directives, both in its basic design
and construction as well as in the version put into circu-
lation by us. This declaration shall cease to be valid if
the machine is modified without our prior approval.
The signatories act on behalf of and with the authority of
the company management.
Documentation supervisor:
S. Reiser
Alfred Kärcher SE & Co. KG
Alfred-Kärcher-Straße 28-40
71364 Winnenden (Germany)
Tel.: +49 7195 14-0
Fax: +49 7195 14-2212
Care and maintenance
Maintenance instructions
Maintenance contract
Replacing filter inserts
Replacing pre-filter inserts
Replacing membrane filter (reverse osmosis)
inserts
Replacing activated carbon filter
EU Declaration of Conformity
Product: Water treatment plant
Type: 1.024-xxx
Relevant EU Directives
2014/35/EU
2014/30/EU
2011/65/EU
Applied harmonized standards
EN 60335–1
EN 62233: 2008
EN 55014–1: 2006+A1: 2009+A2: 2011
EN 55014–2: 2015
EN 61000–3–2: 2014
EN 61000–3–3: 2013
EN 50581
Applied regulations
-
Chairman of the Board of Management Director Regulatory Affairs & Certification
12 EN