Kärcher T-Racer T 400 Plus, Руководство пользователя

Страница: 8 / 88

8 English
You need to use the matching high-pres-
sure nozzles to ensure that your high-pres-
sure cleaner works properly.
Note: Nominal pressure (p): See Operating
Instructions or type plate of your high-pres-
sure cleaner.
e.g.: K 6 – K 7, Kärcher 600 – Kärcher 770
Î Use yellow high-pressure nozzles.
Note: The yellow high-pressure nozzles
have already been installed.
e.g.: K 4 – K 5, Kärcher 201 – Kärcher 560
Î Use grey high-pressure nozzles.
Î Illustration
1 Loosen the safety clamp with a screw-
driver.
2 Remove the protective grid.
3 Change the high pressure nozzles.
4 Mount the protective grid on the pin.
5 Push the safety clamp in until it locks.
Note : Always use Kärcher water filter (or-
der no. 4.730-059.0) during suction opera-
tions of the high-pressure cleaner.
Fasten the T-Racer to the high-pressure
gun using the extension pipes.
Î Illustration
1 Screw the two extension pipes together.
2 Press the extension pipe into the bayo-
net catch of the T-Racer.
3 Turn it by 90° until it locks into place.
4 Tighten the safety cover.
Î Illustration
1 Press the extension pipe into the bayo-
net catch of the high pressure gun.
2 Turn it by 90° until it locks into place.
3 Tighten the safety cover.
Î Adjust the turning handle "power" as
per the surface to be cleaned
„ Outdoor surfaces should be swept be-
fore the T-Racer is used to avoid dam-
aging the high-pressure nozzles.
„ The T-Racer is not suited for scouring
or scrubbing!
Caution
Î Illustration
Do not run over free-standing corners!
Fasten the T-Racer directly to the high-
pressure gun.
1 Press the bayonet connection of the T-
Racer into the connection of the high-
pressure gun, then turn by 90° until it
locks into place.
2 Tighten the safety cover.
Î Adjust the turning handle "power" as
per the surface to be cleaned
Caution
Î Illustration
Always hold the T-Racer at the handle
while cleaning the walls.
Preparing the Appliance
Selecting the high-pressure nozzles
High-pressure cleaner with nominal
pressure (p) of 13 MPa (130 bar) to 16
MPa (160 bar)
High-pressure cleaner with nominal
voltage (p) lesser than 13 MPa (130 bar)
Changing the high-pressure nozzles
a Remove the clip.
b Pull out the yellow high-pressure nozzle.
c Insert the grey high-pressure nozzle.
d Re-insert the clip.
Application
Cleaning floor surfaces
Tips for cleaning
Cleaning wall surfaces