Kärcher SE 5.100, Руководство пользователя

Страница: 17 / 210

– 9
suction turbine will otherwise start run-
ning again once you open the appli-
ance.
 Release and remove the appliance
head.

Remove the wastewater container and
empty it.
 Rinse the spray tubes in the appliance
as follows:
Fill the detergent container with about 1
liter of clear water.
Hold the nozzle above the drain, and
switch on the spraying pump until the
clear water has been consumed.
–
Always work from the light to the shade
(from the window to the door).
–
Always work from the cleaned to the un-
cleaned surface.
–
Rugs with jute backing can shrink if too
much water is used and can bleed col-
ours.
–
Brush high-fiber rugs in the direction of
the weave after cleaning (using a fiber
brush or a scrubber).
–
Water-proofing the fabric using Care
Tex RM 762 after the wet cleaning pre-
vents a quick resoiling of the textile sur-
face.
–
To eliminate mite, we recommend our
anti-allergenic carpet cleaner RM 772,
with long-term effect.
–
Do not step on cleaned surfaces until
they have dried and do not place furni-
ture on them to avoid pressure spots or
rust stains.
With light to normal contamination (reg-
ular cleaning)
:
 Turn on suction and spraying.
 Spray and simultaneously suction off
detergent solution in one work cycle.
 Switch off the spray switch and suction
off the remaining cleaning solution.
 After cleaning the carpets, reclean them
using clear, warm water and waterproof
if needed.
Heavy soiling or stains (basic cleaning):

Switch on the spray.

Apply detergent solution and soak for
10 to 15 minutes (suction is switched
off).
 Clean the surface just like you would
with light/normal soiling.
 After cleaning the carpets, reclean them
using clear, warm water and waterproof
if needed.
몇
Caution
The reservoir and accessories must be dry
to prevent parts from sticking together.
 Remove the wastewater and fresh wa-
ter containers.
Illustration

Recommendation : To vacuum fine
dust, use the filter bag.
Illustration
 Use the adapter for wet/dry vacuuming
Attach the adapter to the handle, turn
the locking handle to secure it.
 Select the desired accessories and at-
tach to the spray/suction pipes or direct-
ly to the attachment.
 Switch on the vacuum process.
Note : Do not switch on the spray.
Illustration
 If the filter cleaning indicator is red:
Change filter bag when vacuuming with
a filter bag.
Repeatedly activate the filter cleaning
mechanism when vacuuming without a
filter bag.
Vacuuming hard surfaces
Illustration
 Use your foot to press the reversing
switch of the floor nozzle. The brush
strips at the bottom of the floor nozzle
are extended.
End wet cleaning process
Cleaning tips/mode of operation
Cleaning methods
Dry vacuum cleaning
17 EN
Downloaded From Vacuum-Manual.com Manuals