Kärcher RBS 6000, Оригинальное руководство пользователя

Страница: 14 / 96

-
3
1 Rotary knob for dosing pump*
2 Switch for dosing pump*
3 Handle
4 Safety switch (brush)
5 Mains plug
6 Shutoff valves for nozzle pipes
7 Main switch
8 Water connection
9 Emergency-stop button
10 Incline crank
몇
WARNING
Risk of injury and damage! Observe the
weight of the system when you transport it.
This system can be transported on the bed
of a lorry laying down:
 Remove the spacer rollers.
 Tilt the system onto the brush side with
two people.
 Slide the system onto the lorry bed.
 Secure the system from sliding.
1 Splash guard
2 Pin
3 Expanding rivet
4 Angle profile
The two angle profiles are attached to the
frame with expanding rivets for transport,
 remember the installation position of
the angle profiles for the assembly
process.
 Hit the pins of the expanding rivets to-
ward the inside with a punch.
 Remove the angle profiles.
 Roll out the included spray guard and
place it on the square pipe.
Note:
The spray guard strips are ondulated on
their short side. During installation, this on-
dulation must face away from the brush.
 Reinstall the angle profile.
 Insert the expanding rivet through the
angle profile, spray guard and the
square pipe and press in firmly.
 Hit the pin of the expanding rivet with
the hammer.
 Repeat this process for all bores in the
angle profiles.
 Fasten the two included spacer rollers
on the frame of the system.
Select the height according to the vehi-
cles to be washed.
 Tighten the counter nuts.
The following systems do not include a
dosing pump in the standard scope of deliv-
ery:
–
1.286-235.0
–
1.286-245.0
–
1.286-345.0
–
1.286-435.0
–
1.286-445.0
 Fasten the dosing pump on the frame of
the system with the included fasteners.
Control elements
Transport
Initial Start-Up
Install spray guard
Install the spacer rollers
Install the dosing pump
14 EN