Kärcher PROCHEM Peak GTX2, Руководство по эксплуатации

Страница: 55 / 146

53
Notes
PROBLEM CAUSE SOLUTION
Excessive heating
Flow restriction caused by hard
water scaling.
Descale unit, repair or replace damaged
plumbing components as necessary.
Install water softener.
Baffle door inside heat exchanger
stuck in heating mode.
Unstuck unit, repair or replace damaged
plumbing and electrical components as
necessary.
Not enough water flow. Check jet size of tool.
Heat exchanger leaks. NOTE: The
heat exchanger will produce water
condensation discharge at times
during normal operation. DO NOT
confuse this with a leak.
Engine/vacuum exhaust heat
exchangers are damaged from
frozen water.
Inspect heat exchangers for leaks.
Visually inspect for damage. Pressure
check after removing from the unit.
(Maximum test pressure 1200 PSI).
Loss of temperature. The heat
output of the unit is LESS than
normal.
Temperature relief valve on water
box is stuck open. Clean temperature relief valve and test.
Replace, if necessary.
Engine RPM is low. Reset engine RPM.
Baffle door inside heat exchanger
stuck in divert mode.
Unstuck unit, repair or replace damaged
electrical components as necessary.
Clean solenoid air filter.
Defective temperature gauge.
Test gauge and sensor. Replace failed
component.
Automatic waste pump is malfunc-
tioning or not operating normally.
NOTE: When replacing either the
pump or float switch on internal (in
tank) pumpout, use new electrical
connectors and heat shrink. Inspect
connection for watertight seal.
Defective waste pump float switch. Replace float switch.
Broken diaphragm. Replace diaphragm.
Weak battery.
Charge or replace battery if
needed.Check charging station.
Pump-out circuit breaker on control
panel has been tripped.
After inspecting waste pump to
determine the cause of the tripped
circuit breaker, press the reset button.
86411120 Manual Operators - Peak GTX2 Prochem