Kärcher PC 100 M1 Bio, Руководство пользователя

Страница: 5 / 44

English
5
The detergent in the container is heat-
ed by the heating element and trans-
ported to the cleaning tools by the
pump. These can then be controlled
via the corresponding shut-off valves.
Solid dirt particles are held back by the
strainer in the rinsing floor or in the un-
derlying filter mat.
Grease and oily dirt is rinsed back into
the container and is then degraded into
carbon dioxide and water by the mi-
crobes.
The microbes are first caught in the fil-
ter mat and are then transported by the
liquid detergent into the container. The
liquid detergent must be heated in the
container so that the microbes can
function optimally.
–
Please read the operating instruc-
tions for your machine before using
it, and pay particular attention to the
following safety instructions.
–
Warning and information plates on
the machine provide important di-
rections for safe operation.
–
In addition to the information con-
tained in the operating instructions,
all statutory safety and accident
prevention regulations must be ob-
served.
DANGER! HIGH VOLTAGE. Discon-
nect power before removing the
cover.
Switch off the appliance and pull out
the power cord before cleaning and
performing any maintenance tasks on
the appliance.
–
The voltage indicated on the type
plate must correspond to the volt-
age of the electrical source.
–
Class I - Appliances may only be
connected to sockets with proper
ground.
–
It is recommended connecting this
appliance to a socket that has a 30
mA ground fault circuit protector.
–
Please use the supply cord pre-
scribed by the manufacturer; the
same is also applicable when you
replace the cords. For type details
see spare parts list.
–
Never touch the mains plug with
wet hands.
–
Make sure that the power cord or
extension cords are not damaged
by running over, pinching, dragging
or similar incidents. Protect the cord
from heat, oil, and sharp edges.
–
The extension cord must have the
cross-section listed in the circuit
plan and be protected against
spraying water. The connection
must never be submerged in water.
–
If couplings of the power cord or ex-
tension cord are replaced, the
splash protection and the mechani-
cal tightness must be ensured.
Please dispose of used filter mats ac-
cording to the local regulations for
waste containing mineral oil.
Function
Safety instructions
Symbols on the appliance
Power connection