– 3
–
For connection values, see technical data
and type plate.
–
The electrical connections must be done by
an electrician according to IEC 60364-1.
Danger
Danger of injury by electric shock.
–
The appliance may only be connected to al-
ternating current.
–
The voltage indicated on the type plate
must correspond to the voltage of the elec-
trical source.
–
The minimum fuse rating required at the
socket outlet is (see technical specifica-
tions).
–
Check the power cord with mains plug for
damage before every use. If the power cord
is damaged, please arrange immediately
for the exchange by an authorized custom-
er service or a skilled electrician.
–
The plug and coupling of the extension ca-
ble used must be watertight.
–
Unsuitable extension cables can be haz-
ardous. Only use extension cables out-
doors which have been approved for this
purpose and labelled with a sufficient cable
cross section:
Caution
–
Observe regulations of water supplier.
–
Impurities in the inlet water can damage
the unit. Kärcher recommends the use
of a water filter (Order no. 2.638-270.0).
For connection values refer to technical
specifications
Î
Connect the supply hose to the water
connection point of the machine and at
the water supply point (for e.g. a tap).
Note
The supply hose is not included.
Î
Open the water supply.
Î
Deaerate the appliance:
Unscrew the nozzle.
Switch on the appliance and let it run
until the water exiting is bubble-free.
At the end let the appliance run for ap-
prox. 10 seconds - then switch off. Re-
peat the procedure for a couple of
times.
Î
Switch off the appliance and fit the noz-
zle again.
Danger
Risk of explosion!
Do not spray flammable liquids.
If the appliance is used in hazardous areas
(e.g. filling stations) the corresponding
safety provisions must be observed.
Caution
–
Clean engines only at places with corre-
sponding oil separators (environmental
safety).
Start up
Electrical connection
Water connection
Connection to the water supply
Operation
15
EN