Kärcher HD 10/16-4 Cage, Руководство пользователя

Страница: 20 / 310

20
English
You can rectify minor faults yourself with
the help of the following overview.
If in doubt, please consult the authorized
customer service.

Risk of injury
Always switch off the appliance and pull out
the mains plug before care and mainte-
nance work.
몇
Warning
Repair work and work on electrical compo-
nents may only be performed by the author-
ized customer service in non-explosion
danger areas.
– No power
Î Check the plugs and sockets.
Î Check whether the voltage indicated on
the type plate corresponds to the volt-
age of the socket.
Î Check the mains connection cable for
damages.
– Engine is overheated
Î
Switch off appliance and let it cool
down. Remove the cause of the prob-
lem. Turn on the appliance again.
– Wrong nozzle
Î Check nozzle for correct size (see tech-
nical specifications).
– Air within the system
Vent pump:
Î Unscrew the nozzle. Switch on the ap-
pliance and let it run until the water ex-
iting from the spray pipe is bubble-free.
Switch off the appliance and fit the noz-
zle again.
– Nozzle is blocked/ washed out
Î Clean/ replace nozzle.
– Filter at the water connection is dirty
Î Clean filter at the water connection.
– Amount of water supply is too low.
Î Check water supply level (refer to tech-
nical data).
– Pipe inlets to pump are leaky or blocked
Î
Check all supply lines to the high-pres-
sure pump for leaks or blockages.
Î 3 drops per minute are permitted and
can come out from the lower side of the
appliance. Call Customer Service if
there is heavy leakage.
– Pipe inlets to pump are leaky or blocked
Î Check all supply lines to the high-pres-
sure pump for leaks or blockages.
– Air within the system
Vent pump:
Î
Unscrew the nozzle. Switch on the ap-
pliance and let it run until the water ex-
iting from the spray pipe is bubble-free.
Switch off the appliance and fit the noz-
zle again.
– Exchange nozzle plugged
Î Clean the exchange nozzle with com-
pressed air.
– Amount of water supply is too low.
Î Check water supply level (refer to tech-
nical data).
Dispose of old oil ecologically or turn in at
a gathering point.
Maintenance schedule
Wear parts Operating
hours
High-pressure/low-pres-
sure seals 1000 h
Suction/pressure valves 1000 h
O-rings/support rings of the
overflow valve 1000 h
Ball bearing of the pump
gear 2000 h
Oil races, shaft seal 2000 h
Troubleshooting
Appliance is not running
Device is not building up pressure
High pressure side is leaky
High pressure pump is vibrating
Water jet is not uniform