Kärcher Basic T-Racer, Руководство пользователя

Страница: 6 / 64

6 English
Please read and comply with
these original instructions prior
to the initial operation of your appliance and
store them for later use or subsequent own-
ers.
„
Please observe the safety instructions
of your high-pressure cleaner.
„
Only trigger the high-pressure jet at the
high-pressure gun if the T-Racer is lo-
cated on the surface to be cleaned.
„
There must be no persons in the imme-
diate vicinity of the cleaning head.
„
Beware of the recoil force! Ensure a
stable position and firmly hold the high-
pressure gun with the extension tube or
the handle.
„
Switch off the high-pressure cleaner
when you finish cleaning. If you are us-
ing the T-Racer then disconnect the
same from the high-pressure gun.
„
Maximum water temperature 60°C
(please observe the instructions of your
high-pressure cleaner).
When unpacking the product, make sure
that no accessories are missing and that
none of the package contents have been
damaged. If you detect any transport dam-
ages please contact your dealer.
Î
See page 2, illustration
1 Casing
2 Handle
3 Turning handle "power" (to adjust the
height of the nozzles)
4 Foot pedal for edge cleaning
5 Foot pedal for surface cleaning
6 Bayonet connection with safety cover
7 Extension tubes (two tubes)
8 Rotor arm
9 Green high-pressure nozzle
10 High pressure nozzle
Danger!
Do not hold under the edge of the
T-Racer when it is on!
The T-Racer is ideally suited for the clean-
ing of floor and wall surfaces made of differ-
ent materials, such as wood, plastic,
concrete, tiles, and natural stone. Use the
T-Racer exclusively in your private house-
hold.
Note : Always use Kärcher water filter (or-
der no. 4.730-059.0) during suction opera-
tions of the high-pressure cleaner.
Fasten the T-Racer to the high-pressure
gun using the extension pipes.
Î
Illustration
1 Screw the two extension pipes togeth-
er.
2 Press the extension pipe into the bayo-
net catch of the T-Racer.
3 Turn it by 90° until it locks into place.
4 Tighten the safety cover.
Î
Illustration
1 Press the extension pipe into the bayo-
net catch of the high pressure gun.
2 Turn it by 90° until it locks into place.
3 Tighten the safety cover.
Î
Adjust the turning handle "power" as
per the surface to be cleaned
„
Outdoor surfaces should be swept be-
fore the T-Racer is used to avoid dam-
aging the high-pressure nozzles.
„
The T-Racer is not suited for scouring
or scrubbing!
Caution
Î
Illustration
Do not run over free-standing corners!
Safety instructions
Description of the Appliance
Symbols on the machine
Proper use
Application
Cleaning floor surfaces
Tips for cleaning