
不喷水
喷水强度弱
水温不热
座温不热
风温不热
不出风
喷杆不缩回
喷杆不伸出
遥控器不显示
除臭功能不
正常工作
进水管弯折造成部分堵塞
进水阀关闭
自来水断水
进水管弯折造成堵塞
进水阀未完全打开
进水滤网阻塞
水温设定常温档
座温设定常温档
处于待机模式
风温设定常温档
处于待机或节电模式
断电
被异物卡住
断电
未坐到着座感应区
遥控器电池正负极装反
使用者没有接触座圈上的感应器
离开座圈后,除臭功能继续工作
排除进水软管弯折
打开进水阀
等待来水
排除进水软管弯折
完全打开进水阀
清洗进水滤网
重新设定水温档位
重新设定座温档位
切换到功能模式3分钟使用
重新设定风温档位
切换到功能模式使用暖风功能
将喷杆轻轻推回,等待来电
清除异物
等待来电
位置坐正,坐到感应区
重新装电池,对准正负极
调整至接触到座圈上的感应器
使用者离开座圈后,除臭功能会继续工作一段时间,
确保完全消除异味,这是正常现象
如果按上述方法处理后故障仍未排除,应切断电源,联系服务商,请专业人员维修。
如果电源漏电保护开关时常跳开,表示产品有漏电,请切断电源,联系服务商,请专业人员维修。
注意:
22
23
三
Problem
Malfunction
of deodorization
Cause
Water supply hose buckling causes block
Fill valve is off
No flushing
Poor flushing
Fill valve is not fully turned on
Filter is dirty and causes block
In standby mode
Solution
Solve the buckling
Turn on the fill valve
Connect water supply and wait for the water
Solve the buckling
Turn on the fill valve fully
Clean the filter
Reset the water temperature
Reset the seat temperature
Shift to function mode for 3 minutes
The water is
not hot
Seat temperature
is not hot
Wind temperature
is not hot
No wind out
spray wand
cannot retracted
Spray wand
cannot stretch
out
Controller
cannot display
In standby mode or power
save mode
Get stuck by impurities
Do not sit in sensing area
Reverse the polarity of battery
User doesn't reach the sensing area in seat
Deodorization functio keeps working
after user leaves
It's a normal phenomenon if deodorization function
keeps working after user leaves to ensure eliminating
smell entirely
Adjust to reach the sensing area
Reload the battery
Sit right in the sensing area
Push back the wand lightly and
wait for the power
Clear away the impurities
Push back the wand lightly and
wait for the power
Shift to function mode to use
dry function
Reset the wind temperature
Water supply is cut off
Water supply hose buckling causes
partial block
The water temperature is setted
on normal temperature level
The seat temperature is setted
on normal temperature level
The wind temperature is setted
on normal temperature level
Power off
Power off
TROUBLESHOOTING GUIDE
TROUBLESHOOTING GUIDE
造成的
由
材料
三
400-920-8262
PRECAUTIONS
400-920-8262
中国(上海)自由贸易试验区西里路55号13层
1348部位
Содержание 21042T-WK
Страница 14: ...24 25...