MICRO REMOTE
6
changed. This will unclone the
transmitters. If this is desired,
use the following procedure:
1.
Make sure the receiver and
transmitters are OFF
2.
Press and hold buttons
ROLL LEFT, IDLE HIGH,
BOOM, and POWER until
the LEDs start to toggle.
Release buttons
3.
Press any button again to
select a new ID
4.
Uncloning complete
5.
Use
transmitter
and
receiver
synchronization
procedure above to link the
uncloned transmitter to
new receivers
BATTERY CHARGING
The battery can be charged by
plugging the AC wall charger or
DC cigarette charger into the
USB port. Red and green LED
indicators near the top of the
transmitter indicate the status of
the charger: A red LED indicates
that the battery is charging and
a green LED indicates that the
battery is fully charged.
IMPORTANT BATTERY INFO
When the battery is new, the
run-time of the transmitter will
be shorter until it has gone
through the drain/charge cycle
several times. After this point,
the unit’s current drain should
allow at least 20 hours of run-
time before a recharge is
needed.
The
temperature
that
the
transmitter battery is exposed to
affects performance and useful
life. It is strongly recommended
you keep within the following
limits:
A.
Charging: -4 to +86
F
B.
Operating: -20 to +122
F
