13.
Input Slave/Output Master Mode
This mode switch is used to combine two amplifiers together to power
large sub-woofer(s)
For a single amplifier configuration, use the mode switch in the
“
Output Master
” position.
For a dual amplifier configuration, Master amplifier is the first unit
connected to the source unit. Set the mode switch to “
Output
Master”
position. The Slave amplifier is the attached to the Master,
set the mode switch to “
Input Slave”
position. (See wiring diagram)
14.
Power
Indicator
The LED indicates the amplifier is functioning properly when the
LED is lit.
15.
Protection
Indicator
The LED will light up red and will flash if there is a fault detected by
the amplifier. Disconnect the amplifier. Check and fix the connections
to resolve the fault condition. (See Trouble shooting guide)
16.
SLAVE IN
accepts level input from the
Master Output
using and RCA
cable.
17.
Master Output
produces level output for slave amplifier
Connections
B
EfOrE
CONNECTEd
ANy
pArTs
Of
ThE
spEAKErs
,
ENsUrE
ThE
spEAKErs
ArE
NOT
ENErgIzEd
ANd
ThAT
ANy
INpUT
sOUrCE
Is
sWITChEd
Off
.
1.
Input
- (Item 5) Be sure to lay the signal wire away from all
power cables and vehicle computers. Use high quality twisted pair
interconnect cables to decrease the possibility of radiated noise
entering the system.
Using RCA Connections, simply attach a signal cable from the source
unit to the amplifier’s RCA input.
See wire diagrams for setup of sub-woofers and amplifiers
2.
Power Terminals
- Please take proper measures during installation to
protect the power wires as best you can. For example, when running
the power cable from the vehicle’s battery through the firewall, use
a firewall bushing for protection. Run the power wire through the
interior of the vehicle, under the carpet, and to the amplifier. If this
- 6 -
2000w Mono Block Amplifier
