Step 1: Attach side bracket (seen on left image) to the backboard using the
bolt, lock washer, and nut provided (the side
bracket that has rectangle slot will be left side
of your Wall Map(s) when fully assembled; NOT
the rounded hole side bracket). Make sure to
line up the punch holes on the side bracket to
the punched holes on the backboard when
tightening.
Step 2: Take Wall Map(s) mounted on spring roller and insert the rectangle end
into the backboard side bracket you have just attached to the backboard. BE
CAREFUL NOT TO TURN OR APPLY PRESSURE TO THE RECTANGLE END OF ROLLER
WHILE PLACING INTO SIDE BRACKET. (Note: This end has been tensioned to
properly operate wall maps once mounted to backboard and wall)
Step 3: Attach the second side bracket (contains rounded hole) to the backboard
with the spring roller inserted into the bracket as you tighten the bolt, lock washer
and nut again making sure punched holes are in alignment.
Now you are ready to hang the Wall Map(s) and backboard onto the wall.
PUNCHED HOLES IN SIDE
BRACKET ARE PLACED INTO
HOLES ON BACKBOARD
