17
10
10
10
10----4 Overlap of the upper and lower knives
4 Overlap of the upper and lower knives
4 Overlap of the upper and lower knives
4 Overlap of the upper and lower knives
When upper knife J is at the bottom of its stroke,
adjust the overlap of the upper and lower knives as
shown in the illustration. To increase the overlap,
loosen screw K on the upper knife lever and move
the upper knife in the direction of arrow X.
To decrease the overlap, move the upper knife in the
direction of arrow Y. When the correct overlap is
achieved, tighten screw K.
10
10
10
10----5 Adjusting the stroke of the upper knife
5 Adjusting the stroke of the upper knife
5 Adjusting the stroke of the upper knife
5 Adjusting the stroke of the upper knife
Set the stroke of the upper knife at approximately
8mm. To change the stroke, loosen nut L on the
upper knife adjusting lever pin.
■
To decrease the stroke, move lever pin M in the
direction of Y.
■
To increase the stroke, move lever pin M in the
direction of X.
After the adjustment, tighten nut L securely.
Adjustment of the stroke will change the overlap of
the upper and lower knives.
Be sure to achieve the correct overlap by referring to
10-4.
10
10
10
10----6 Resharpening the knives
6 Resharpening the knives
6 Resharpening the knives
6 Resharpening the knives
Since the upper knife is made of a superalloy, there
is no need to resharpen it about one year.
If cutting does not occur, resharpen the lower knife.
