9
Set and crimp permanently the linkages at the
rudder end of the cable.
Temporarily connect rudder servo to your radio
system to find and hold center. Ensure that Tx
trims are neutral.
You also should consider blocking the rudder in
neutral with a couple of clamps and balsa sticks,
Now complete the connection of the pull / pull
system to the rudder.
Finally, complete the rudder control / tail wheel
assembly by installing the 2 springs between the
tail wheel and rudder. Ensure that the spring are
secure, however final install should be left until
you have taken a couple of taxi runs.
Fuselage/ Upper Wing Cabanes
Locate the 4 cabane pieces. NOTICE that there
are 2 long and 2 shorter cabanes. The LONG
cabanes are fitted to the rear positions while the
longer ones fit in the front positions.
Slide the cabanes through the slots located in the
fuselage. They fit BEHIND the ply plates.
Using the 8 – 3 mm X 12.75 mm bolts, insert
them in the holes in the ply plate and tighten
them into the metal cabanes. The bolts will “tap”
into the cabanes.
