Supplied By www.heating spares.co Tel. 0161 620 6677
KANE455
manual
Page
27
8. ANALYSER
PROBLEM
SOLVING
If any problems are not solved with these solutions, contact us or an authorized
repair center.
Fault symptom
Causes / Solutions
•
Oxygen too high
•
CO
2
too low
•
Air leaking into probe, tubing, water trap,
connectors or internal to analyser.
•
CO reading (- - - -)
•
Analyser was stored in a cold environment
and is not at normal working temperature.
•
CO sensor needs replacing.
•
Pump is switched off
•
Batteries not holding
charge
•
Analyser not running on
mains adapter.
•
Batteries exhausted.
•
AC charger not giving correct output.
•
Fuse blown in charger plug.
•
Analyser does not respond
to flue gas
•
Particle filter blocked.
•
Probe or tubing blocked.
•
Pump not working or damaged with
contaminants.
•
Net temperature or
Efficiency calculation
incorrect.
•
Ambient temperature set wrong during
Automatic Calibration.
•
Flue temperature readings
erratic
•
Temperature plug reversed in socket.
•
Faulty connection or break in cable or plug.
•
T flue or T nett displays
(- - - -)
•
Probe not connected.
•
X-Air, EFF display (- - - -)
•
CO
2
reading is below 2%.
