KAMWELD KAM-TC1000, Руководство по эксплуатации и инструкция, Страница: 15 / 22

15
be displayed then.
30 Lock 188 AH 290
AL 0
AST ON
SET
3 sec
SET
SET
SET
SET
SET
SET
SET
Figure 10. Parameter setup flow chart under (code 188).
6. Save and recall
Program
This controller can save up to 8
Program
. Each
Program
file can have up to 6 steps (C-1 to
C-6). For convenience, we have pre-named these 8 pieces of
Program
files as B1 , B2, C1 ,
C2, F1 , F2, P1 , and P2. These
Program
files are all the same except their names, so you
can store your special
Program
to any of them. These
Program
can be stored in the memory
of the controller even when it is powered off. You can overwrite the exist
Program
with a new
one.
6.1
Save a
Program.
After a program has been entered, the user can save this current program as a
Program
for
future use. Under the normal operating mode, press and hold SET key for 3 seconds
until the Parameter Window displays “LoCK”. Release the SET. The display will show “0”. Use
“+” and “-” keys to adjust the display to 2 and press SET. The display will show “SAVE” for a
second and then the value “End”. If press SET key now, you will exit this mode without
overwriting any existing programs. Use “+” or “-” key to select the name of
Program
to which
you want to store the program. If you press “+” (or “-” key) repeatedly, you will see “End”, “b1”,
“b2”, “C1”, “C2”, “F1”, “F2”, “P1”, “P2” one by one. Press the SET key again to store your
current program under the selected
Program
name. This process will overwrite the current
Program
data to the saved
Program
data. Figure 11 shows the flow chart of how to save a
Program
.