5. Technical data
Operating and switching voltage:
230V~ 50/60Hz
Outputs:
Heating:
relay make contact, max. 5(1)A 5(1)A
Cooling:
relay make contact, max. 1(0.2)A
Fan:
3 speed switch,
relay make contact, max. 3(1)A
Control range:
18
… 26°C
Switching difference:
0.5K at a temperature change of 4K/h
Neutral zone:
settable within a range from 0.5 to 6K
(factory setting 2K)
Tolerance of internal sensor:
approx. 1K
Optional external sensor:
NTC 47K / 25°C
Power consumption:
< 1W / < 2VA
Protection class:
II (after conforming installation)
Degree of protection:
IP30 (after conforming installation)
Admissible ambient temperature:
0
… 45°C
Storage temperature:
-20
… 70°C
Admissible moisture:
max. 95% RH, non-condensing
Mounting:
surface or wall mounting
Housing material and colour:
plastic (ABS), pure white,
similar to RAL 9010
Imprint colours:
Labelling / Logo:
- Blue grey, similar to RAL 7031
Control knob:
- signal red, similar to RAL 3001
and light blue, similar to RAL 5012
Equipment:
- ON/OFF switch
- 3-speed fan switch
- Reference setter with mechanical range
limitation
- Internal switch for selection between
internal (factory setting) / external
temperature sensor
- Internal switch for selection between "fan
ON" (factory setting) or "fan OFF" within the
neutral zone.
- Setting mark backlit (two colours)
6. Data table with external sensor data
(characteristic curve)
The table shown below applies to the optional external temperature sensor.
7. Wiring diagrams and dimensioned drawings / overview of switch positions
Caution:
Make sure to mount
the partition for the safe
separation between mains
voltage and safety extra low
voltage accordingly.
8. Warranty
The technical data specified in these instructions have been determined under laboratory conditions and in compliance with generally approved test regulations, in
particular DIN standards. Technical characteristics can only be warranted to this extent. The testing with regard to the qual
ification and suitability for the client’s
intended application or the use under service conditions s
hall be the client’s own duty. We refuse to grant any warranty with regard thereto. Subject to change without
notice.
