Kampa Kielder DA, Руководство по эксплуатации

Страница: 14 / 16

EN
14 4445103669
Using the awning tent
!
Before first use
Familiarize yourself with the product by carrying out a test set up before
the product is used for the first time. Check if the scope of delivery is
complete.
Choosing a site
Choose a flat site that is protected from wind:
1. If necessary, use a windbreak.
2. Choose a shaded site to avoid UV degradation of the fabric.
3. Avoid pitching under trees as falling branches, resin, etc. can damage
the product.
4. Clear the site of sharp stones and debris to avoid damaging the
groundsheet.
5. Set up the product with the doors facing away from the wind.
Setting up the awning tent
Kielder DA AIR only
!
A
Kielder DA and Kielder DA AIR
A
I
Keep the following tips in mind while setting up the awning tent:
• The figures provide a general overview of the set-up. The actual set-up
will vary slightly based on the model of awning tent.
• Get help. The set-up is easier with more people.
• Push the poles into the sleeves from front to rear.
• After standing the awning tent upright, check the corner pegs and re-
peg if necessary. The groundsheet on the inside should be taut and in
a rectangular shape.
• Peg the guy lines so that the awning tent is under tension without dis-
torting the shape.
• If available, attach the storm straps.
• Check the guy lines from time to time to ensure adequate tension, if
necessary use the runners to adjust.
Set up the awning tent as follows:
1. To protect the awning tent from dirt and damage, lay down a ground-
sheet or footprint before unpacking.
2. Unpack the awning tent.
3. Separate and identify the different components.
4. Set up the awing tent as shown:
– Kielder DA : fig.
2
, page 3 to fig.
d
, page 7
– Kielder DA AIR: fig.
e
, page 8 to fig.
q
, page 11
Dismantling the awning tent
A
Kielder DA only
1. Remove any dirt on the outside.
2. Close all window blinds or remove curtains.
3. Close all doors and openings.
4. Push the poles out of the sleeve, do not pull.
5. Remove all lines and straps.
6. Remove all pegs between the corner pegs.
7. Ensure that all parts are clean before packing in the carry bag.
8. If the awning tent is wet or damp, dry fully as soon as possible.
Kielder DA AIR only
1. Remove any dirt on the outside.
2. Close all window blinds or remove curtains.
3. Close all doors and openings.
4. Push the canopy pole out of the sleeve, do not pull.
5. Remove all lines and straps.
6. Remove all pegs between the corner pegs.
7. Open the valves on each pole.
8. Wait until most of the air has been expelled.
9. Remove the four corner pegs.
10. Fold/roll the awning tent towards the valves to expel more air.
11. When deflated, roll the awning tent to fit into the carry bag.
12. Ensure that all parts are clean before packing them into the carry bag.
13. If the awning tent is wet or damp, dry fully as soon as possible.
Storing the awning tent
I
1. Clean the awning tent.
2. Air fully and ensure the awning tent is totally dry before packing away.
3. Store in a well ventilated dry place.
CAUTION! Risk of injury and material damage
Never open the zipper on the protective sleeve while an air
pole is inflated. This will result in the air pole bursting.
CAUTION! Risk of injury and material damage
• Do not use any type of compressor designed to inflate
car tires.
• Only inflate the air poles into the green zone of the
pressure gauge of the supplied hand pump (7 –
8 psi/0.48 – 0.55 bar).
NOTICE! Damage hazard
If a wind-out awning is used to attach the awning tent,
support the wind-out awning while working to avoid putting
too much stress on it. After attaching the awning tent,
rewind the wind-out awning fully back into its housing.
NOTICE! Material damage
Do not open or close the zippers by force.
NOTE
• The awning tent comes with general purpose pegs.
These will be suitable for many sites but for some types
of ground special pegs will be needed. Ask your dealer.
• Drive the pegs at a 45° angle away from the awning tent
into the ground.
• Peg each guy line in-line with the seam it starts from.
NOTICE! Damage hazard
Do not use force when dismantling the awning tent. Other-
wise you might damage any material.
NOTE
• Fully set up the awning tent for cleaning.
• Choose a sunny day for cleaning to ensure the material
will dry thoroughly.