Before assembly
•
We recommend that time is taken to
read the instructions before starting
assembly, then follow the easy step
by step guide.The instruction sheet
is only a guide to the assembly.
Certain items may not be shown to scale.
•
Check all components prior to assembly
•
This product should be assembled
by no less than two people.
•
Never attempt to erect the assembly
in high winds.
•
Drill all components where indicated.
Recommended tools for assembly
•
Cross head screw driver
•
Drill with 3mm diameter drill bit
•
Hammer
x 2
Drill
No.
Components
Qty.
1
Side base frame
2
2
Back base frame
1
3
Left wall panel
(Width 785mm)
1
4
Right wall panel
(Width 785mm)
1
5
Left back panel
(Width 705mm)
1
6
Right back panel
(Width 705mm)
1
7
Support rail
1
8
Top frame
1
9
Planting trough
1
10
Trough liner
1
11
Front rail
1
12
Left door
(Width 705mm)
1
13
Right door
(Width 705mm)
1
No.
Fixing kit
Qty.
14
Metal L-brackets
2
15
100mm screws
5
16
80mm screws
9
17
50mm screws
29
18
32mm screws
8
19
10mm nails
40
20
Hinge
4
21
Turn button
2
22
50mm screws
5
23
25mm screws
34
1
2
3
4
5
6
7
8
9
10
11
Kanny Bin Canopy
Assembly Instructions
English SS352C
If in doubt of any aspect regarding the assembly, use or safety of your product please contact us :
Help Line (Normal Office Hours) 01829 261 121
ROWLINSON GARDEN PRODUCTS LIMITED
Green Lane
Wardle Nr. Nantwich
Cheshire
CW5 6BN
We constantly improve the quality of our products, occasionally the
components may differ from the components shown and are only
correct at time of printing. We reserve the right to change the
specification of our products without prior notice.
2015 © Rowlinson Garden Products Ltd
25mm
12
13
6. Doors
Attach each door using two hinges and 8 x 25mm per hinge as shown. Position the top hinge approximately 180mm
from the top of the door. Position the bottom hinge approximately 180mm from the bottom of the door.
25mm
Caution
it is recommended the
Kanny Bin Store is
bolted to a solid surface.
50mm
7. Front rail and turn buttons
Position the front rail flush to the bottom edge of the top frame. Secure in place using 5 x 50mm screws. Screw through
the frame into the ends of each angled rafter. Attach a turn button above each door and secure each one to the front
rail using 1 x 25mm screws for each turn button.
Drill
It is recommended to drill pilot
holes for the front rail screws with
a 3mm drill bit before assembly.
Please Note:
Diagrams in this section show assembly with
planting trough removed for visual purposes
only. It is not necessary to remove the
trough to fit these parts.
