4
4445103822
5
1.
2.
9120000389
2.
1.
7 - 8 psi
5
6
7
8
3
4
Pump up each AIR Pole. The pump has a pressure gauge and
each AIR Pole should be inflated to between 7-8 psi. As each
AIR Pole is inflated the tent will lift.
It may be necessary to go inside the tent and push the AIR
Poles upwards so that they can assume their correct shape.
Once all the AIR Poles have sprung outwards assuming their
correct shape, detach the pump from the tent and tighten
the outer valve cap on each inflation point. It is important
that each cap is refitted to prevent the seepage of air.
You may need to use a guy rope to keep the tent upright in
place whilst pegging.
Close all doors and entrances and check the positioning of
the corner pegs again. If necessary re-peg to ensure that
the groundsheet is taut inside the tent and the shape is
rectangular.
Peg the intermediate pegging points at the front and back
of the tent.
Your tent comes with guy lines pre-attached. We
recommend that these are used at all times. Peg the guy
lines so that the tent is under tension without distorting
the shape.
The guy lines can be adjusted using the runners and should
generally be pegged in line with the seam of the tent that it
starts from. Check the guy lines from time to time to ensure
that they are still adequately tensioned.
KampaKielder4-5-6AirDeluxe_OPM_4445103822_EMEAen_20xx-xx-xx.indb 4
KampaKielder4-5-6AirDeluxe_OPM_4445103822_EMEAen_20xx-xx-xx.indb 4
23.09.2022 10:51:11
23.09.2022 10:51:11
