ELECTRIC PRUNING SHEARS
ELECTRIC PRUNING SHEARS
44
45
www.kamikazevolpi.com
www.kamikazevolpi.com
PL
Instruk
cja użytkownika
PT
Manual de uso
FR
Guide de l
’utilisat
eur
EN
User’
s manual
ES
Manual de uso
10. CHARGING THE BATTERY
Do not dispose battery under high temperature or vibration
environment to avoid liquid leakage from the battery.
Disconnect the battery from tool before charging.
Always make sure the battery is dry and clean before charging.
• Make sure the battery is fully charged before first time using.
• The battery is not fully charged when you buy, you must charge 2,5 hours
before using first time.
• Before recharging the battery, check the remaining charge on the display.
• Need to replace battery if battery running time is not enough. Users can
only use the original equipment manufactured by the customer center
(OEM) battery pack.
• Keep safety rules and environment protection information in mind all the time.
10.1. BATTERY CHARGING PROCEDURE
• Charge at temperature of +10°C~ 22°C indoor.
• The three-way battery charger allows you to recharge the three batteries
supplied at the same time.
• Make sure specifications on battery and adapter matched before charging.
• Connect the plug of the battery charger to the battery to recharge it (if it
is necessary it is possible to connect all three batteries at the same time).
• The batteries will be recharged simultaneously.
• The Red LED on the battery charger indicates that charging is in progress,
the Green LED indicates that the batteries are fully charged. The average
charging time is 2/3 h for each battery.
• Please make sure the battery charged at least once every 4 months when
the battery is not using.
11. WORKING ENVIRONMENT
• Keep temperature of environment at 10°C ~ 22°C when charging battery,
0°C ~ +45°C when battery is working.
• Keep tool at temperature of 0°C ~ +60°C when working
• Do not use in explosive atmosphere or near flammable substances or gases.
• Do not use in case of rain or on wet branches
12. ASSEMBLY
Check that the pruning shears and batteries
are clean and dry, and then place the battery in
the battery compartment on the pruner.
13. OPERATIONS START PROCEDURE
Please wear suitable cloth and glove when operate this tool.
Always check tools before use, make sure on/off switch and safe
switch are all ok. The power should be put off when you loosen the
trigger. Stop using the tool in case of switch failure. Always check rated
voltage of battery match pruning shear.
Switch off the machine, blade will stop in many second, must sure
blade stop fully before touch it, otherwise blade will hurt your body.
• Press the power switch. After warning tone, please pull the trigger two
times without holding. Do not overload cutting, it will protect pruning
shear and battery not be damaged. Do not cutting over the dimension
specified in the technical information table.
• User just loose trigger when the blade has been jammed by branch, the
blade will resume maximum position.
