11
10
Before First Use
Remove all packaging and protective
coverings from the heater and ensure
that all parts are accounted for
before disposing of the packaging
material.
Place the heater on a flat, level
surface in an upright position. Check
the front and back air grilles to ensure
there is nothing blocking the airflow.
WARNING:
This heater is
not to be wall or ceiling
mounted.
WARNING:
Children
should be supervised to
ensure that they do not
play with the heater.
Using Your Kambrook Ceramic Heater
Using the Remote Control
Remove the remote control from the
plastic cover and remove the plastic
tab inserted in the battery cover at
the bottom of the remote.
To replace the battery, open the
battery compartment at the bottom
of the controller. Remove the old
battery and replace with a new
battery, ensuring that it is correctly
inserted (Fig. 1). Reinsert the battery
compartment into the remote control.
Fig. 1
NOTE:
This remote control
requires 1 x CR2032 3V lithium
battery to operate.
The remote control for this heater has
the same functions and buttons as
the control panel on the top of the
heater.
Operating the heater
Plug the power cord into a 230V or
240V power outlet and switch on.
Switch the heater ON using the main
power switch located at the back of
the heater, below the fan grille.
When power is switched on, the
heater will beep twice and go into its
default setting of STANDBY mode. In
STANDBY, the LCD screen will show the
current room temperature but will not
be emitting any heat (Fig. 2).
Fig. 2
NOTE:
The room temperature
display on the LCD screen is an
indicative temperature based on
the thermostat designed within
the heater. Temperatures further
away from the heater itself may
be different.
Heat Settings
Press the MODE button to select
your desired heat setting. The
MODE button will cycle through
the 4 settings: LOW – HIGH – AUTO –
STANDBY.
- Low mode – the heater will operate
with low power.
- High mode – the heater will operate
with high power.
- Auto mode – set the desired
temperature and the heater will
operate using variable temperature
control.
- Standby mode - the heater has
power but does not emit any heat.
Variable temperature control only
operates when the heater is set to the
AUTO mode. When set to AUTO, use
the
(
)
buttons to select the desired
room temperature, ranging from 5°C
to 32°C. The heater will automatically
cycle between the low and high
modes to achieve and maintain the set
temperature.
Oscillation
The oscillation function allows the
heater to thoroughly distribute air in
the area in which is it placed, emitting
up to 140 degrees of heat coverage.
The oscillation function can be used
with the LOW, HIGH and AUTO heating
modes.
Press the OSC button on the control
panel or remote control and the heater
will begin to oscillate from side to side
in a 60° movement.
Press the OSC button again to turn this
function off.
WARNING:
In order to
avoid overheating, DO
NOT COVER the heater.
NOTE:
Variable temperature only
operates when the heater in set
to the AUTO mode.