9
8
Quick Start Guide
Turning the heater on
1.
Plug the power cord into
a 230V or 240V power
point and switch on.
2.
Switch the heater on
using the main power
switch located on the
back of the heater,
below the back fan
grille.
3.
The heater will go into
STANDBY mode.
Setting the mode
Oscillation
1.
Press the MODE button
to select your desired
setting. The mode button
will cycle; LOW – HIGH –
AUTO – STANDBY.
2.
Once desired heat
mode is displayed on
the LCD screen, wait
for the screen to stop
flashing, indicating the
selection has been
confirmed.
1.
Press the OSC button
and the heater will start
to oscillate from side
to side. Press the OSC
button again to stop the
oscillation.
Setting the temperature in AUTO mode
1.
Press the MODE button
until the AUTO mode is
selected.
2.
Use the (
)
buttons
to adjust to the desired
room temperature (see
note).
3.
Once the desired
temperature is displayed,
wait for the screen to
stop flashing, indicating
the selection has been
confirmed.
Setting the auto-off timer
1.
Once the MODE has
been selected, press the
TIMER button. The screen
will flash the timer setting.
2.
Using the (
)
buttons, select the
desired time, ranging
from 0.5 hours to
8 hours. Wait for the
screen to stop flashing,
indicating the timer has
been set.
3.
When the timer
countdown is complete,
the heater will switch
into standby mode. If the
heater is not needed for
further use, switch off at
the main power switch on
the back of the heater.
NOTE:
The time needed for the heater to meet the set desired room
temperature in AUTO mode will vary based on various factors, such as
the heat setting selected, the size of the space to be heated, the starting
temperature, etc.
NOTE:
The room temperature display on the LCD screen is an indicative
temperature only based on the thermostat set within the heater.
Temperatures further away from the heater itself may be different to this
reading.