Powered by KAM Systems Limited
www.nursecallshop.co.uk
User Guide
i
2
Series
Powered by KAM Systems Limited
www.nursecallshop.co.uk
Wireless Motion Sensor installation and user guide
i
2
Series
User Guide
IT IS IMPORTANT TO NOTE AFTER THIS STAGE
PLEASE REFRAIN FROM ACTIVATING ANY TYPE OF
PENDANT / SENSOR ALARM, THIS COULD END IN
ACCIDENTAL ADDITIONS TO THE RECEIVER UNIT.
• Press the enter button once located on the side of
the unit, the Green LED will pulse in sequence to
the slot number. There are 10 slots slot 1 will cause
the Green LED to Pulse once, Slot 2 will Pulse twice
ending with slot 10 pulsing 10 times in a sequence.
• The red LED will show the user if the slot is taken
by an existing device or free to add a new device.
If the RED LED pulses the slot is free to add a new
device. If the RED LED is solid the slot is currently
occupied by a device.
• Once a free slot is found activate the pendant
/ sensor by pressing the button or creating
movement in the case of motion sensors. A
successful alarm will be confirmed with a red LED
on the pendant / sensor and a successful receiver
addition will show the pulsing RED LED change to a
Solid RED LED.
• Once completed, switch from LEARN back to
OPERATE to continue with normal function.
• Both LED should be off.
TEST your work by activating your Pendant /
Sensor. The red Led will flash on for a short period.
Deleting a PENDANT / SENSOR
• A Pendant / Sensor can be deleted from the
receivers memory. Simply plug the supplied
12v power supply from the receiver unit into an
electrical outlet.
• Located underneath the receiver unit is a switch
that will allow the user to switch from OPERATE
(normal function position) to LEARN (ability to add
new sensors).
• Slide the switch to the LEARN position.
• At this point the Green LED will pulse slowly to
show that you are in the engineering menu.
IT IS IMPORTANT TO NOTE AFTER THIS STAGE
PLEASE REFRAIN FROM ACTIVATING ANY TYPE OF
PENDANT / SENSOR ALARM, THIS COULD END IN
ACIDENTAL ADDITIONS TO THE RECEIVER UNIT.
• Press the enter button once located on the side of
the unit, the Green LED will pulse in sequence to
the slot number. There are 10 slots slot 1 will cause
the Green LED to Pulse once, Slot 2 will Pulse twice
ending with slot 10 pulsing 10 times in a sequence.
