Powered by KAM Systems Limited
www.nursecallshop.co.uk
User Guide
i
2
Series
Adding additional Pendants / Sensors
• Simply plug the supplied 12v power supply from
the receiver unit into an electrical outlet.
• The LEDs on top of the receiver unit will NOT
illuminate.
• Plug the supplied nursecall lead from the
nursecall point to the Receiver unit.
PLEASE MAKE SURE THAT THE SWITCH LOCATED
UNDERNEATH THE RECEIVER UNIT IS SET TO
OPERATE.
When the motion sensor is activated the red LED on
the receiver will illuminate for a short period. (This
reassures the user that the alarm was transmitted
and received correctly)
Wireless Motion Sensor installation and user guide
Installation / Operation
The receiver unit will allow the addition of up to
10 wireless accessories such as wrist alarms, neck
pendants, motion detectors etc. These can be
ordered on Nursecall shop.
The ability to add multiple Pendants / Sensors can
benefit the user greatly, it will allow them to have
multiple ways to alarm a single nursecall point. It also
allows multiple users in large areas such as a lounge /
garden to call for help.
To program a new pendant / sensor please follow the
following steps:
IMPORTANT! Before programming a motion
sensor apply the blinding cover and let the
sensor cooldown for a two minute period.
• Simply plug the supplied 12v power supply from
the receiver unit into an electrical outlet.
• Located underneath the receiver unit is a switch
that will allow you to switch from OPERATE (normal
function position) to LEARN (ability to add new
sensors).
• Slide the switch to the LEARN position.
• At this point the Green LED will pulse slowly to
show that you are in the engineering menu.
Powered by KAM Systems Limited
www.nursecallshop.co.uk
i
2
Series
User Guide
