Kalor Mignon 6, Инструкция по установке и эксплуатации

Страница: 21 / 25

44
GB
Any inconvenience and solutions
Given that all stoves are tested in their parts handling and work and therefore are delivered in perfect physical condi-
tion and operation, it should be remembered that the transport, unloading, handling, misuse or poor maintenance,
can be causes of drawbacks.
The main problems may be solved by reading the table below.
If after doing as hereinafter described the problem is not resolved, contact your authorized service center.
Problems and solutions
All repairs must be carried out exclusively by a specialised technician, with the stove completely
cold and the electric plug pulled out. Is prohibited from any unauthorized modification to the
device and the replacement of parts with other non-original. The operations marked in bold type
must be carried out by specialised personnel.
PROBLEM POSSIBLE CAUSE REMEDY
Display off and but-
tons are not working
1. Power failure in the network
2. Switch back off
3. Display defective
4. Fault in the connection of the
display with the card
5. Fuse board interrupted
6. Card defective
1. Check that the power cord is connected
2. Use the switch back to operate it
3. Unplug the stove from the power outlet for about
one minute and then turn on. If the problem persists,
contact an authorized service center
4. Check that the display and board are prop-
erly connected. Contact your authorized service
center
5. Contact an authorized service center
6. Contact an authorized service center
Remote inefficient
1. Too far from the stove
2. No batteries in the remote
3. The remote control is broken 1. Move closer to the stove
2. Check and change the batteries
3. Replace the remote control
Failure to ignite
the stove
1. Excessive accumulation of ash
in the grate
2. Incorrect ignition procedure 1. Clean the grate
2. Repeat the ignition procedure.
If the problem
persists, contact your authorized service center
Smoke comes from
the grill
1. Accidental electrical blackout
1. In case of ignition phase interrupted and momen-
tary interruption of the fan, can occur slight amount
of smoke
Hot air fan is not
working 1. The stove has not yet been
heated
1. Wait until the conclusion of the ignition cycle.
Arrived in temperature, the fan will start automatically.
If the problem persists, contact your authorized ser-
vice center.