Kalor Francesca 17B, Руководство пользователя

Страница: 12 / 50

10
EN
Flue connection
The joint between the Thermostove and the fl ue
must be installed using suitable tubes (min. T200).
Use is forbidden of fl exible metal tubes, in cement
fi bre or aluminium. The slope of the smoke duct
must not have horizontal sections over 2 metres
and must have a minimum 3% inclination. The
fi rst change of direction must take place after at
least 1.5 metres of the vertical section. Inspect the
base of the smoke duct
with periodic controls. It is forbidden to connect
the same smoke duct on multiple equipment. Keep
the smoke duct an adequate distance from any
fl ammable parts or parts sensitive to heat. Refer to
the instructions given by the manufacturer of the
fl ue for the distances to respect.
A= MINIMUM 40 MM
B=MASSIMUM 4 M
C= MINIMUM 3°
D= MINIMUM 400 MM
E= DIAMETER OF HOLE
F= SEE FIG. 2-3-4-5-6
U= INSULATION
V= POSSIBLE REDUCTION FROM 100 TO 80 MM
I= INSPECTION PLUG
S= INSPECTION DOOR
P= AIR INTAKE
T= T JOINT WITH INSPECTION PLUG
U
2
3
F
U
1
I
S
P
I
4
B
D
A
T
I
I
U
E
V
I
C
The remote control (Fig. 3) used to adjust water temperature power
and the on/off functions for the pellet Thermostove.
To start the Thermostove, press key and the Thermostove will
automatically enter the starting phase.
Press keys + (1) and - (2) to adjust temperature, and use keys +
(6) and - (5) to adjust operating power.
To turn off the Thermostove, hold down key .
To replace the 3 volt battery located on the back of the remote control,
pull the centre of the cover and the lever on the side of the same,
replace the battery observing the correct polarity (Fig. 4)
Remote Control
Fig. 3 Fig. 4