Kalmar DRD450-80S4X, Руководство по обслуживанию

Страница: 69 / 600

UDRF01.04GB
Maintenance manual DRF 400–450
1 Engine – 1.2.3 Fuel pre-filter 11
1 Machine in service position, see section B Safety .
2 Place a receptacle under the fuel pre-filter.
3 Clean the area around the fuel pre-filter.
4 Drain the fuel pre-filter of fuel and water.
Open the drain valve on the underside, close the valve when
the filter is empty.
5 Disconnect the wiring from the sensor for water in fuel.
6 Remove the fuel pre-filter with the filter tool.
7 Transfer the water trap to the new fuel pre-filter.
8 Lubricate the O-ring on the new fuel pre-filter with engine oil.
9 Fit the new fuel pre-filter.
Tighten to contact and then another half to three-quarter turn.
10 Connect the wiring to the sensor for water in fuel.
11 Turn on the main electrical power and start the engine. Check
that the filter seals tight.
12 Turn off the engine and remove the receptacle. Handle the fuel
as environmentally hazardous and inflammable waste.
page –
Fuel pre-filter, draining condensation water (Volvo
engine)
NOTE
The fuel pre-filter should be drained of water every 50 operating
hours.
Fuel pre-filter, drain valve and connector for water in
fuel sensor
NOTE
Avoid skin contact with fuel, use gloves. Fuel on hands may
cause rashes and irritation.
NOTE
Wait a few hours until the engine has cooled down before drain-
ing condensation water from the fuel pre-filter.
1 Machine in service position, see section B Safety .
2 Place a receptacle under the fuel pre-filter.
3 Open the drain valve on the underside and let the condensation
water drain. Close the valve when clean fuel drains (no water
bubbles).
4 Remove the receptacle. Handle the fuel as environmentally
hazardous and inflammable waste.
D A N GE R
Pay attention to the fire hazard when working on
the fuel system.
https://www.forkliftpdfmanuals.com/