Kalmar DCE80-100E, Техническое руководство

Страница: 276 / 317

DCE80-100E
Technical Handbook
Sidelift attachment
Service
16 P. Group 80
TDCE01
04GB
Sidelift with hook coupling
Indicating lamps on sidelift
Lamp A (Green): Locking plates locked
Lamp B1 (orange): Alignment against container,
extinguished when the container is lifted
Lamp B2 ( orange ): Alignment on hooks,
the light is on after lift
Lamp C (Red): Locking plates unlocked
Optional : Both B1 and B2 must be lit
before the locking plates can be unlocked.
N.B. B1 and B2 indicate two different alignment signals from
the sidelift. This is to facilitate fault tracing if lamp B in the
cab should not light up when coupling a container.
Alignment control
A spring-loaded contact pin and an inductive sensor at each side
is used for alignment control against the container. The sidelift is
fully in contact with the container when both pins have been de-
pressed and the distance between each pin and sensor is less
that 8 mm. On the hook-coupling sidelift there is an additional
alignment lamp B1 and B2. B2 lights up when the hooks have
been pressed down enough for activation of sensor 8. When both
B1 and B2 light up the locking plates are ready for locking.
Checking of ALIGNMENT indicating lamps B1 and B2
Option: Electrical interlocking system
1. Check that the contact pins in the corner boxes are freely
moveable in and out. A pin which binds in the inner position
may indicate correct alignment although the attachment is not
in contact with the container.
Lubricate the contact pins when needed.
2. Check that the indicating lamp ALIGNMENT B1 lights up
when the sidelift is fitted to the container.
3. Check that the indicating lamp ALIGNMENT B2 lights up
when the hooks are engaged in the container.
4. Check that the lamp B1 is extinguished when the container is
lifted.
5. Option : Lift an empty container just enough to make the lamp
B1 go out. Check that it is impossible to unlock the locking
plates.
6. The sensor 7, se picture, for alignment should be adjusted to
give a signal when the contact pin is depressed.
See Inductive sensors, page 17.
Indicating lamps on sidelift
A
B1
C
B2
KL1687
7 8
KL1688
4 9 10
4. Side locking plate
7. Sensor, alignment against container
8. Sensor, alignment on hooks
9. Sensor, locking plate locked
10. Sensor, locking plate released
11. Spring-loaded contakt pin, alignme-
nt against container
12. Activator for sensor 9
11
12
12
WARNING!
Whenever the indicating lamps do not work properly, the
attachment should be taken out of service for repair. The
use of an attachment with faulty indication lamps could
be hazardous!