INSTALLATION INSTRUCTIONS
Tuxedo™ Console Table
1102264_2_B
Page 5 of 5
Questions? Problems? For additional assistance, please contact Kallista’s Customer
Service Department at 1-888-4KALLISTA (1-888-452-5547) or FAX 1-888-272-3094.
INSTALL THe ReAR CONSOLe TABLe LeGS (OPTIONAL)
5.
Adjustment
Pad
Adjustment
Pad
Threaded
Rod
Threaded
Rod
Lift slightly to install
optional rear legs
Measure the distance from the floor to the un-
derside of the stone top, at the rear leg mounting
locations. Turn the adjustment pads on the leg
feet to the measured heights for each rear leg.
With an assistant or two,
put the rear legs into
their floor mounting holes. Lift the rear of the
stone console top slightly off the wall bracket,
and tilt the rear legs under the stone top, so the
threaded rods protruding from the top of the legs
are inserted into the appropriate holes in the bot-
tom of the stone console top.
Gently lower the stone console top onto the wall
bracket and rear legs. Confirm the top is still
level, adjust as needed.
Apply a small amount of caulk or silicone sealant
where the legs meet the stone console top.
Install the 16mm screws and fender washers
through the wall bracket into the threaded holes in
the underside of the stone console top.
Three faucet holes have been partially drilled from the underside of the console top.
On the top, show surface, of the console top, locate the center of the required faucet holes. Using a com-
pass or circle template, draw a circle for the required holes.
Using a small hammer, create the faucet hole(s) by gently tapping the console top within the circles until
the stone breaks away.
NOTe: dO NOT strike the console top with too much force. dO NOT strike from the bottom side of the console
top. This will damage the top surface of the console top.
Using a file or sanding cylinder, complete the removal of stone material to create a clean round hole.
If desired, apply a bead of caulk or silicone sealant where the stone console top meets the wall.
Install the faucet and drain according to the manufacturer’s instructions.
Connect the water supply and check for leaks.
STONe TOP HOLe FABRICATION (OPTIONAL)
6.
COMPLeTe THe INSTALLATION
7.
