INSTALLATION INSTRUCTIONS
Tuxedo™ Console Table
1102264_2_B
Page 3 of 5
Questions? Problems? For additional assistance, please contact Kallista’s Customer
Service Department at 1-888-4KALLISTA (1-888-452-5547) or FAX 1-888-272-3094.
PRePARe THe SITe
1.
Finished
Floor
Wall Bracing
(2x6 minimum)
CL
Finished
Wall
34”
31”
32”
Floor to top
of Bracket
Mark the
anchor
holes.
Console Table
Bracket Anchor
Holes
Foot
Anchor
Holes
CL
16-29/32”
13-29/32”
18-5/8”
Foot
Anchor
Holes
1-7/16”
Rough-in the water supply lines and the drain piping.
Install a minimum of a 2x6 as a wall brace to provide support
for the wall bracket. The brace should be the same length as
the console table, 36” and should be positioned 34” from the
finished floor to the top edge of the board. The center of the wall
brace should be in-line with the drain outlet.
Finish the wall.
Mark the centerline on the floor and the wall.
Mark the anchor holes for the console table mounting bracket
on the wall by holding the bracket up to the finished wall so that
the center of the bracket lines up with the centerline. Mark the
location of the anchor holes with a pencil.
Mark the location of the holes on the floor for the feet anchors.
Drill a hole 1/4” D. x 1/2” deep, in the finished floor for each foot
anchor. The holes should be 18-5/8” from the wall and 13-29/32”
from the centerline for the front legs and 1-7/16” from the wall
and 16-29/32” from the centerline for the optional rear legs.
INSTALL THe MOUNTING BRACKeT
2.
Console Table
Mounting Bracket
Install the console table mounting bracket to the finished wall with fas-
teners suitable for your wall type.
Verify the table mounting bracket is level.