Questions? Problems? For additional assistance, please contact Kallista's Customer
Service Department at 1-888-4KALLISTA (1-888-452-5547) or FAX 1-888-272-3094.
INSTALLATION INSTRUCTIONS
Bolt Cap
Nut
Washer
Bolt Cap
Base
Floor Bolt
Bead of Sealant
Side
Mounting
Hole
Mounting
Hole Marks
Bidet
Outline
1085230-2-A
Page 2 of 2
P71040
Persephone 3-Hole Bidet
2. INSTALL THE BIDET
3. COMPLETE INSTALLATION
Connect the water supplies and drain.
Turn on the hot and cold shut-off valves. Check the entire installation for leaks. Repair as required.
Check all connections for leaks for several days.
Install the bidet faucet and drain according to the manufacturer’s instructions.
Set the bidet on the floor in its mounting location.
Trace the outline of the bidet base, and mark the location of the two side mounting holes.
Remove the bidet from the mounting location.
Drill two 3/16” holes at the marked side mounting hole locations.
Thread the floor bolts (included) into the mounting holes.
Apply a bead of sealant around the base of the bidet, and carefully align the bidet inside the outline
drawn on the floor.
Position the bidet in the mounting location so both of the floor bolts extend through the bidet side
mounting holes.
CAUTION: Risk of personal injury or product damage. Vitreous china can break or chip easily
if the nuts are overtightened or the product is handled carelessly.
Assemble the bolt cap bases, washers, and nuts. Hand-tighten the nuts, then tighten an additional
1/2-turn with a wrench.
If the floor bolts extend more than 1/4” from over the top of the nut, loosen the nut and thread the bolt
further into the floor. Retighten the nuts, and install the bolt caps.
