background image

INSTALLATION INSTRUCTIONS

Original For Him Dressing Table 

1008300_2_A

3 of 6

Questions?   Problems?   For additional assistance, please contact Kallista’s Customer

Service Department at 1-888-4KALLISTA (1-888-452-5547) or FAX 1-888-272-3094.

1. INSTALL The dReSSINg TABLe

 

‰

Measure and mark 36-1/4″ (921 mm) up from the floor. This will 

be the height from the top of the 2x6 backing material to the 

floor.

 

‰

Secure the 2x6 backing material to the studs with framing nails.

 

‰

Install the water supply and drain lines. The water supply 

nipples must extend at least 3″ (76 mm) beyond the finished 

wall material.

 

‰

Complete the finished wall. Make sure that the finished wall is 

straight and plumb, and that the floor is flat and perpendicular 

to the finished wall.

IMPORTANT!

 Do not install any moldings that may inhibit the 

dressing table from being plumb against the finished wall.

 

‰

Position the dressing table against the finished wall.

 

‰

Verify the dressing table is level front to back and side to side. If necessary, 

adjust the levelers on the bottom of the dressing table.

 

‰

Mark the supply and drain locations on the inside of the dressing table back 

wall. Move the dressing table away from the wall.

 

‰

Cut the marked supply and drain locations from inside of the dressing table 

using a hole saw.

 

‰

Position the dressing table against the wall, aligning the supply and drain 

locations with the cut holes on the dressing table back wall.

2. TeST fIT The dReSSINg TABLe

  36-1/4” 

(92.1 cm)

2x6 Backing Material 

Отзывы: