INSTALLATION INSTRUCTIONS
Original For Him Dressing Table
1008300_2_A
2 of 6
Questions? Problems? For additional assistance, please contact Kallista’s Customer
Service Department at 1-888-4KALLISTA (1-888-452-5547) or FAX 1-888-272-3094.
We appreciate your commitment to Kallista quality products. Please take a moment to review this manual
before you install your Kallista product. If you encounter any installation or performance problems, please do
not hesitate to contact us at the phone number listed at the bottom of the page.
BefORe yOU BegIN
These instructions are for installing the dressing table (P73015) and pre-cut marble top (P73032).
Observe all local plumbing and building codes.
Prior to installation, unpack the new dressing table and marble top and inspect them for damage. Return
the dressing table and marble top to their protective cartons until you are ready to install them.
Refer to the dressing table specification sheet for P-trap and supply location recommendations. Verify your
supply valves and P-trap will not interfere with the shelf and drawer. Install the water supply and drain lines.
The water supply nipples must extend 3″ (76 mm) beyond the finished wall material.
These instructions are for installing the dressing table to wood frame construction. For other installations,
supply suitable bracing and fastening devices of sufficient size and strength.
Provide 2x6 backing material in the finished wall. The height from the top of the 2x6 backing material to the
floor must be 36-1/4″ (921 mm).
This installation is recommended to be done with a minimum of two people.
The marble top can be installed with three different faucet configurations:
● ″Single-Hole″ for a monoblock faucet
● ″Three-Hole″ for a widespread faucet
● ″No-Hole″ for a wall-mount faucet
All dimensions given assume that the floor and walls are square, plumb, and level. Make appropriate
adjustments for other conditions.
Remove any moldings that may inhibit the dressing table from being flush against the finished wall.
Make sure the path of the shelf will not be obstructed as it slides open.
Kallista reserves the right to make revisions in the design of products without notice, as specified in the
Price Book.
ThANk yOU fOR ChOOSINg kALLISTA
TOOLS ANd MATeRIALS
Pencil
Tape
Measure
Level
Drill
Hex
Wrench
Clear 100% Silicone
Sealant or Caulk
File
Hammer
Safety Glasses
Plus
● Conventional woodworking
tools and materials, as
appropriate
● Hole Saw
● Wood Screws
● Screwdriver
