INSTALLATION INSTRUCTIONS
3-way Transfer Valve Trim
1091608-2-
G
4 of 6
Questions? Problems? For additional assistance, please contact KALLISTA’s Customer
Service Department at 1-888-4-KALLISTA (1-888-452-5547) or kallista.com.
2. ADJUST THE HANDLE ASSEMBLY
Valve Stem Adapter
Spline Adapter
Handle
Assembly
"B"
"A"
"C"
Combined
"B" and "C"
Accessory "B"
Accessory "A"
Accessory "C"
Mixed Water Supply
Combined
"A" and "C"
Combined
"A" and "B"
NOTE:
Valve Operation. Water will
fl
ow from a single shower accessory when the control knob detent lines up
with any of the large detents on the escutcheon. Water will
fl
ow from two accessories at the same time when
the control knob detent is centered between two large detents on the escutcheon.
Ensure the valve stem adapter is lightly placed over the spline adapter.
Place the handle assembly over the valve stem adapter.
Turn on the water supply to the transfer valve.
Rotate the handle assembly until water begins to
fl
ow through the shower accessory.
Determine the shower accessory that will correspond to the Accessory
″
A
″
setting at the 12 o’clock position
on the escutcheon.
Turn the handle to the detent setting that corresponds with Accessory
″
A.
″
The handle should be in the
vertical 12 o’clock position.
Remove the handle assembly and set aside.
Handle Alignment Adjustments
NOTE:
The spline adapter allows
fi
ne adjustment of the handle alignment.
Remove the handle assembly and the valve stem adapter.
Reposition the spline adapter.
Reinstall the handle assembly and the valve stem adapter.
Check the alignment.
Repeat until the handle alignment is satisfactory.
