INSTALLATION INSTRUCTIONS
Single-Control Lavatory Faucet
1177267-2-
C
4 of 5
Questions? Problems? For additional assistance, please contact KALLISTA’s Customer
Service Department at 1-888-4-KALLISTA (1-888-452-5547) or FAX 1-888-272-3094.
2. INSTALL The dRAIN
Thick Tapered Gasket
(for Thin-Walled Vessel
Style Lavatory Installations)
Tapered Gasket
Nut
Drain Body
Washer
Flange
If present, remove the protective plastic cap from the drain and discard.
Remove the nut, washer, and gasket from the drain body.
Apply a bead of plumbers putty or other sealant around the underside of the flange according to the
manufacturer’s instructions.
For drains with metal stoppers:
Close the drain and rotate the drain body until the logo is positioned
horizontally.
Insert the drain into the drain hole and press into place.
Slide the gasket (tapered side up) onto the drain body.
Slide the washer over the threads on the drain body.
Thread the nut up the drain body until snug against the underside of the lavatory. Use care not to rotate the
drain while tightening the nut.
Using a wrench, tighten the nut.
Remove any excess putty or sealant.
If the lavatory is not installed, install it at this time. Follow the lavatory manufacturer’s instructions.
