Kalley K-LED55UHDCT2, Руководство по обслуживанию

Страница: 20 / 44

Factory Test & Alignment Specification For RT92-AP Series (V1.0)
13
4.4 LAN/WLAN Test
MAC Address Upgrade
Upgrading MAC address needs to use the tool in factory and through serial command. The specific
method is according to the operation of the factory guidance.
DeviceID (DID) and UserID (UID)
Purpose is to allow Other Network Download (OND) and further specific services over dedicated portal
based on AP.For such, specific DID (32 bytes) and UID (8 bytes) needs to be paired and overwritten into
memory for internal client encryption,as below:
Device ID User ID
BE4F255BBD106BC8F806AE456350D91F 3546187
Those DID/UID codes can only be set using UART commands following enclosed SIACP requirements
(rev. v3.9).
LAN Test
A rough LAN test can be done by connecting Ethernet to TV’s RJ45 and check that IP, subnet mask, DNS
addresses, which are visible on “
Home

Settings

Network Setting

Wired settings

Auto Get IP
Address ” (ensure that “Internet Connection” is Enabled at first). More in
-depth test can be performed
faster using suitable UART/IR commands following SIACP requirements. SW will internally manage
Network ID (NID) flag controlling all MAC/DID/UID integrity to facilitate PA screening further.
See Appendix 3 “N
etwork Connection
”
4.5 SHOP INIT
At final process st
age, it’s necessary to perform
Shop
init before any packing to leave Factory mode and
restore User default presets according to the requirement of order.
This function is accessible by selecting
“ Factory Menu

Shop ”, then pressing RCU “ Right ”or” Left ”
key.
Other faster methods are available on above enclosed SIACP requirements (rev. v3.9).