EN-20
Supplementary guide | Pedelec Bosch Integrale 0.5
3.9
Changing the angle of the front light
Proceed as follows to determine the correct light angle:
1. Position the Pedelec at a distance of 5 meters from a
wall.
2. Measure the height of the front light with a measuring
tape.
3. Mark the height of the front light on the wall.
4. Switch on the light.
5. Lift the front wheel slightly and rotate it so that the
front head lamp lights up.
6. If the light beam hits the wall above the height marking,
it will blind oncoming traffic. The brightest part of the
light beam should preferably be midway between the
ground and the height marking.
1. Loosen the M5 bolt slightly by turning it anticlockwise. At the same
time, secure the locking nut with an 8 mm [0.31 in] open-end wrench.
2. Adjust the light angle so that it does not blind other people.
3. Tighten the M5 bolt again by turning it clockwise. At the same time,
secure the locking nut with an 8 mm [0.31 in] open-end wrench.
3.7
Attaching the reflectors*
Your Pedelec comes supplied with reflectors. Mount the white reflector
on the handlebar, the red reflector on the seat post and the remaining
reflectors on the wheel.
3.8
Switching the lights on and off
There is a ring on the rear of the front
light. Depending on the direction that
you turn it, the front and rear light will
turn
on or off. You will need to step on
the pedals to activate the lights.
Front light
Rear
*dependent on model
